When it comes to working on different ship model kits, all you need to have is a mix of common household tools to a few specialist modeling tools. The following are the four essential tools that you will need to complete a model boat successfully:
1.Sandpaper and sanding blocks Sandpaper or glasspaper comes in a variety of grades – right from coarse to very fine. You will find it crucial to use sandpaper at different times to fractionally adjust a piece of timber or to sand the hull planks smooth when planking is completed. A sanding block is a helpful tool that has sandpaper pasted on each face. Based on the type of application, the set has an assortment of sizes. They are especially helpful at the time of fairing the bulkhead frames of a boat model. 2.Planking Screws At the same time as the PVA glue sets, you will require fixing the hull planks to the bulkhead frames after they have been tapered and curved. You can make use of small brass nails and hammer them through each plank on the bulkhead frame. The nail heads are either cut off or pulled out as soon as the glue has dried. On the other hand, you could make use of map pins that are used in the same way to the nails. They’ve the benefit of being a little bigger than the brass nails and therefore simpler to deal with. The map pin is removed when the glue has set. 3.Plank bender handheld A handheld plank bender is most likely a crucial tool for building ship model kits you will require. After tapering the planks as needed you will require bending them to the desired form n order to fit around the bow and probably the stern of the model. The plank bender has a dull blade edge and a leveled surface in its jaws. Putting a plank on the leveled surface between the jaws and squeezing the handles softly will bring the blade down onto the plank. By smoothly tucking the plank along a length will begin to cause the plank to curve around. 4.Pin vice and drills A pin vice is a handheld chuck for small drills. The swivel top pin vice has a reversible chuck in conjunction with one more reversible chuck in the hand of the shaft. This provides it substantial adaptability in the size of the drills the pin vice can be used with. While building ship models, an assortment of small drills will always be handy. You need to take good care at the time of working with drills particularly the very small items as they are easily broken. While drilling, prevent applying too much push pressure. The pin vice must be turned unhurriedly. 0.5 mm to 2 mm is the usual size of drills used. The variety of tools mentioned above are regarded as the fundamental and essential tools that you will need while building ship model kits. However, as you step forward with the modeling, you’ll buy more tools depending on the needs.
0 Comments
|
AuthorWooden Model Ship Kits of Ages of Sail include everything you need to build each kit including tools, books and accessories. Archives
January 2023
Categories |